Specifications

Last Updated 5/7/13
25
Timer Operation
Pressing the TIMER ON button can
set the auto-on time of the heat pump
mini-split. And pressing the TIMER
OFF button can set the auto-off time of
the heat pump mini-split.
Setting the Auto-on time.
1. Press the TIMER ON button. The
remote controller shows TIMER ON,
the last Auto-on setting time and the
signal "h" will be shown on the LCD
display area. Now it is ready to reset
the Auto-on time to START the
operation.
2. Push the TIMER ON button again to
set desired Auto-on time. Each time
you press the button, the time
increases in 30 minute increments, up
to 10 hours, then at 1 hour increments
up to 24 hours.
3. After setting the TIMER ON there
will be a one half second delay before
the remote controller transmits the
signal to the heat pump mini-split.
Then, after approximately another 2
seconds, the signal "h" will disappear
and the set temperature will re-appear
on the LCD display window.
Setting the Auto-off time.
1. Press the TIMER OFF button. The
remote controller shows TIMER OFF,
the last Auto-off setting time and the
signal "h" will be shown on the LCD
display area. Now it is ready to reset
the Auto-off time to START the
operation.
2. Push the TIMER OFF button again
to set desired Auto-off time. Each time
you press the button, the time
increases in 30 minute increments, up
to 10 hours, then at 1 hour increments
up to 24 hours.
3. After setting the TIMER OFF there
will be a one half second delay before
the remote controller transmits the
signal to the heat pump mini-split.
Then, after approximately another 2
seconds, the signal "h" will disappear
and the set temperature will re-appear
on the LCD display window.