Specifications

Last Updated 5/7/13
9
 Adjust the vertical louver manually.
To set the vertical air flow (Up-Down)
direction, perform this function while
the heat pump mini-split is in operation
by using the remote controller to adjust
the air flow direction. The horizontal
louver can be
moved at a range of 6º for each press,
or swing up and down automatically.
Please refer to the REMOTE
CONTROLLER section.
 To set the horizontal air flow direction
(left - right) move the vertical louver
manually to adjust the air flow in the
direction you prefer.

IMPORTANT: Before adjusting the
vertical louvers, the supply power must
be disconnected.
CAUTION
Do not operate the heat pump
mini-split for long periods with the
air flow direction set downward in
cooling or dehumidifying mode;
otherwise, condensation may occur
on the surface of the horizontal
louver causing moisture to drop on
to the floor or on furnishings.
Do not move the horizontal louver
manually unless it is necessary
(always use the remote controller).
When the heat pump mini-split is
started immediately after it was
stopped, the horizontal louver might
not move for approximately 10
seconds.
Open angle of the horizontal
louver should not be set too small,
as COOLING or HEATING
performance may be impaired due
to overly restricted air flow area.
Do not operate heat pump mini-
split with horizontal louver in closed
position.
When the heat pump mini-split is
connected to power (initial power),
the horizontal louver may generate
a sound for 10 seconds, this is a
normal operation.