Speaker User Manual

Amplifier Specifications

Specifications Are Subject To Change Without Notice

POWER OUTPUT

FREQUENCY RESPONSE

TOTAL HARMONIC DISTORTION

SLEW RATE

SIGNAL TO NOISE RATIO

LOAD IMPEDANCE

DAMPING FACTOR

CONTROLS

INPUT CONNECTIONS

OUTPUT CONNECTIONS

MODE SWITCHES

PROTECTION CIRCUITRY

POWER REQUIREMENTS

IQ-600R=10A

SIZE AND WEIGHT

1 x 1100watts RMS @ 4 ohms Mono (1% distortion)

1 x1500 watts RMS @ 2 ohms Mono (1% distortion)

1 x 700 watts RMS @ 8 ohms Mono (1% distortion)

20Hz-2kHz

<0.08%, (1W/4ohm)

55 volts / microsecond

> 106dB (balanced) 105dB (unbalanced) @ rated power

2 ohms or greater

> 500

XLR / RCA • High-level

Binding posts • Locking mechanism

Phase switch 0° / 180° - Variable time delay 0 to 20 millisecond

Short circuit, open circuit, RF burnout, over temp,

protection, DC protection, limiter circuitry

turn on/off transient

Power • Room equalization • Room equalization IN/OUT • Subsonic

filter • Phase shift • Lowpass, Bypass • Channel and power status

LEDs • Dual gains internally mixed • Music sensing ON/OFF • DC

turn ON/OFF

110-120VAC~/60Hz

H=1.7" x W=19" x D=14.5"

44mm x 483mm x 367mm

26.04lbs. • 12.2Kg

IQ Subwoofer Power Amplifier