Use and Care Manual

Operator’s Manual
Chipper Shredders
10 Check for parts online at w ww.tazztools.com or call 800-345-6007 M-F 8-5
ASSEMBLY
Install Kick Stand (SEE FIGURE 1)
1. Position the kick stand (A) underneath the engine with
the loop of the kick stand pointing away from the wheel
axle (B).
2. Using the four M8-1.25 X 40 bolts, nuts, and eight
washers, secure the kick stand to the base plate of the
engine.
Install the Wheels (SEE FIGURE 2)
1. Slide the wheel onto the axle (B).
2. Slide the 12mm washer (A) onto the axle so that it sits
against the wheel.
3. Insert the cotter pin (C) into the hole in the end of the
axle. Bend the cotter pin over to secure the wheel to the
axle.
Install Chipper Cone (SEE FIGURE 3)
1. Position the chipper cone (A) over the three M8-1.25
threaded studs protruding from the engine plate, and
attach using three M8-1.25 ange nuts (B).
2. Rotate cone and cone base away from engine so cone
does not contact engine.
3. Tighten the ange nuts securely.
Install the Hopper Guard (SEE FIGURE 4)
1. Hold the hopper guard assembly (A) so that the rubber
guard is directed down towards the bottom of the
hopper. Align the assembly holes with the holes in the
shredder hopper.
2. Using the three M6-1.00 bolts, nuts, and springlock
washers, secure the guard assembly to the hopper. Insert
the bolts with washers from the outside of the shredder
hopper.
Install the Handle (SEE FIGURE 5)
1. Hold the hopper handle up so that the outer holes in the
handle align with the holes in the shredder hopper and
secure with M8-1.25 x 20 hex ange bolts, M8 washers,
and M8-1.25 nylock nuts. Insert the screws from the
outside of the shredder hopper.
FIGURE 3 - Installing the Chipper Cone
A. Metal Cone Assembly B. M8-1.25 Flange Nut
A
B
FIGURE 4 - Installing the Hopper Guard
A. Guard Assembly B. M6-1.00 X 16 Bolt
C. M6 Springlock Washer D. M6-1.0 Nut
D
A
C
B
FIGURE 2 - Installing the Wheels
A. 12 MM Washer B. Axle C. Cotter Pin
A
C
B
FIGURE 1 - Installing Kick Stand
A. M8-1.25 x 40 bolt
B. Engine base plate
C. Kick stand
D. M8 washer
E. M8-1.25 nylock nut
A
C
D
E
B