Cycles Guide

11
Operator Manual
R80V, R100 ENGINES
Get parts online at www.GetEarthquake.com or Call 800-345-6007 M-F 8-5 CST
OPEN CHOKE (RUN) POSITION
FIGURE 6
6. After engine begins operating, move choke lever to HALF
CHOKE. SEE FIGURE 5.
7. Run engine for 30 to 45 seconds at “Half Choke” position
until engine warms up. Then return throttle to operating
speed. (This is not necessary on models with throttle xed at
full throttle position.)
8. After starting the engine, slowly move the choke lever to
the RUN position as the engine warms up. Move throttle
to desired speed. SEE FIGURE 3 & 6.
TO STOP THE ENGINE:
1. Set the throttle lever to the low speed position and allow
the engine to run at low speeds for 1-2 minutes before
stopping. (This is not necessary on models with throttle xed
at full throttle position.)
2. On manual-start models, turn the On/O switch to the
OFF position. On models with xed throttle, move ON/
OFF switch to OFF position. SEE FIGURE 8.
3. Pull the starter handle slowly and return the handle
to its original position when resistance is felt. This
operation willprevent outside moisture from entering
thecombustion chamber.
FIGURE 7
FIGURE 8