Cycles Guide
13
Operator Manual
R80V, R100 ENGINES
Get parts online at www.GetEarthquake.com or Call 800-345-6007 M-F 8-5 CST
3. Reinstall drain plug. Remove dipstick (if applicable) or oil
ll cap. SEE FIGURE 10.
4. Fill with appropriate oil to “FULL” or top line of dipstick;
otherwise to top thread of oil ll hole. SEE FIGURE 10.
5. Reinsert dipstick or oil ll cap and tighten.
SPARK PLUG
SPARK PLUG
CAP/WIRE
OIL FILL PORT
& DIPSTICK
OIL DRAIN PLUG
LOWER OIL LEVEL
UPPER OIL LEVEL
FIGURE 9
FIGURE 10
CAUTION
NEVER RUN ENGINE WITHOUT AIR FILTER PROPERLY
INSTALLED. ADDED WEAR AND ENGINE FAILURE MAY
OCCUR IF AIR FILTER IS NOT INSTALLED ON ENGINE.
AIR FILTER
Refer to maintenance schedule for suggestions on when to
service your air lter. Clean lter daily in extremely dusty
conditions.
Remove/Install Air Filter as follows: SEE FIGURE 11.
1. Remove air cleaner cover.
2. Remove the air lter element.
3. Replace with clean or new air lter.
4. Replace air lter cover.
Washing Air Filter as follows:
1. Wash in warm water with mild soap until dirt and debris
are removed. Press lter when washing, do not twist.
2. Rinse in warm water until soap and dirt are removed.
3. Dry lter by wrapping in a clean cloth and pressing lter
until it is dry.
4. Oil lter thoroughly with common household lubricating
oil and press out any excess oil.
5. Attach the lter and air cleaner cover to the engine.
SPARK PLUG
The recommended spark plug can be located in the Illustrated
Parts Breakdown (IPB). The spark plug is located directly under
the muer. SEE FIGURE 12.
CHECKING AND CHANGING SPARK PLUG
1. Check spark plug every 50 operating hours.
NOTE: To make the spark plug more accessible, the muer
may be removed.
AIR CLEANER
BASE
AIR CLEANER
SCREEN
AIR CLEANER
ELEMENT
AIR CLEANER
COVER
FIGURE 11