Owner's manual

Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5 11
Operator's Manual
Front Tine Tiller 3310V
CHECK BELT TENSION

hour of operation, and checked after every two hours of operation. Proper
adjustment will assure long belt life. Too much or too little belt tension will

1. Turn o engine. Engine must be cool.
2. Remove spark plug wire from spark plug and secure.
3. With drive safety control lever in the neutral position, measure
length of spring when in its relaxed state.
4. Pull down on drive safety control lever and measure length of spring
when compressed. Ideal length would be 1/4” shorter. SEE FIGURE 5.
CHANGE FORWARD BELT
1. Turn o engine. Engine must be cool.
2. Remove spark plug wire from spark plug and secure.
3. Remove front belt guard (331027A, Engine Seat Assembly Front).
SEE FIGURE 8.
  
- gently pull the engine recoil rope to rotate the pulley.
- with the pulley turning, force the belt out of the groove.
- slide the belt free of the engine pulley.
- pull the belt down and out of the way.
- push the belt forward and out front of machine.
  
- place belt in transmission pulley groove.
- gently pull the engine recoil rope to rotate the pulley while
forcing the belt into the groove.
4. Replace front belt guard (331027A, Engine Seat Assembly Front).
5. Attach spark plug wire.
BELT GUARD
Figure 8: Belt Tension Adjustment
(331027A, Engine
Seat Assembly,
Front)
WARNING
CHECK FORWARD BELT TENSION REGULARLY.
TOO MUCH OR TOO LITTLE TENSION WILL CAUSE
PREMATURE BELT FAILURE.
ENGINE MAINTENANCE
Refer to the engine manual included in your parts packet for information on
engine maintenance. Your engine manual provides detailed information

1. Check oil level before each use or after every 8 hours of operation.
2. Change oil after rst 5-8 hours of operation. Change oil while engine
is warm. Rell with new oil of recommended grade.
4. Check spark plug yearly or every 100 hours of operation.
5. Service air cleaner.
 
7. Check engine and equipment often for loose nuts and bolts, keep
these items tightened.
CHECK OR FILL ENGINE CRANKCASE
1. Add oil according to engine manual. Do not overll. Use a clean,
high quality detergent oil. Container must be marked A.P.I. Service
SF - SJ. Use no special additives with recommended oils. Do not
mix oil with gasoline. Oil level must be full. Check the oil level by
removing oil ll plug. Oil level should be up to the bottom of the ll
plug opening on most engines.
2. Always check oil level before starting engine. Refer to engine manual
for capacity and type of oil to use.
CLEAN TINE AXLE SHAFT
1. Turn o engine. Engine must be cool.
2. Remove spark plug wire and secure from spark plug.
3. Remove all vegetation, string, wire, and other material that may
have accumulated on the axle between the inside set of tines and
the seal on the transmission housing.
4. Replace spark plug wire.
SERVICING THE ROTOTILLER
The following information will help you make the necessary checks
and perform the procedures required to follow the normal care
recommendations made for your rototiller unit.
If you prefer, your local authorized dealer can make these checks and
perform the required procedures for you.
WARNING
TO PREVENT ACCIDENTAL
STARTING:
ENGINE MUST BE TURNED OFF
AND COOL, AND SPARK PLUG
WIRE MUST BE REMOVED
AND SECURED FROM SPARK
PLUG BEFORE CHECKING AND ADJUSTING ENGINE
OR EQUIPMENT.