Operating instructions

7
ASSEMBLY
GENERAL
All of the major assembly procedures on your new
Chipper/Shredder were performed at the factory, and
only the items listed in this section need to be taken
care of to make your unit fully operational.
TOOLS REQUIRED
• 1/2" Box Wrench or Socket
• 7/16" Box Wrench or Socket
• 1/4" Hex Wrench
• Phillips Screw Driver
• Hex (Allen) Wrench
HARDWARE DESCRIPTION
The hardware pack included with your unit contains the
items listed below. (Additional hardware may be involved
for other models.)
Description Qty.
• BOLT, Hex Head 5/16-18 x 1 1
• BOLT, Hex Head 5/16-18 x 3/4 2
• BOLT, Hex Head 5/16-18 x 1/2 2
• WASHER, Flat 5/16 4
• LOCKWASHER, 5/16 2
• CAPSCREW, Hex Socket 1/4-20 x 3/4 6
• NUT, Flange (Whiz-lock) 1/4-20 6
• WASHER, 1/4 4
Be sure to clean all hardware threads of paint and debris
before assembling.
CHIPPER CONE
1. See Figure 1. Position the chipper cone assembly
base over the three 5/16-18 threaded studs protruding
from the engine plate, and attach using (3) 5/16-18
whiz nuts.
2. Tighten whiz nuts securely using a box or socket
wrench.
HANDLE
1. See Figure 2.Lift the Hopper Handle up until the outer
holes in the handle align with the holes in the
shredder hopper.
2. Secure the Hopper Handle in position using 1/4-20 x
3/4 hex socket screws, and 1/4-20 whiz nuts,
inserting the screws from the outside of the hopper.
3. Tighten all four screws securely.
Figure 2. Installing the Hopper Handle
Figure 1. Installing the Chipper Cone
Figure 3. Attaching Hopper to the Rotor
Figure 4. Installing Hardware Inside Hopper