Instruction manual

2 - 41
2.3.6.13 Arrangement of control blocks
Above controls are placed on SEM and UTILITY tabs by user arrangement.
Open the Operation Panel tab of the Optional setup dialog window by selecting Option menu –
Optional Setup – Op.Panel Setting.
It is recommended to place frequently used controls on
the SEM tab, and others to Utility tab. If you do not use
some controls, remove them from both two tabs.
The names of control blocks are shown on the central
column. Simple description of the function and the view
of the block is shown when you click one of the block
name. When you wish to place the block on the SEM
tab, check the box under SEM tab. To place on the
Utility tab, check the box under Utility tab.
Uncheck both boxes for unnecessary blocks.
Because the tab space is limited, required space for
specified arrangement is calculated and if it is over
available space, the following messages will be shown.
In this case, close the message by OK button and
change arrangement.
[Move a block on the SEM tab to Utility tab.] or [Move a
block on the Utility tab to SEM tab.]
The OK button applies specified arrangement.