Instruction manual

2 - 48
2.3.8.3 Record tab
(1) AUTO DATA DISPLAY block
(1-1) Auto Data Display
Auto data display is engaged when this box is checked.
(1-2) Magnification to Time and Signal Name checkboxes
These items are include in data display if checked.
(1-3) Data Number input box
Input data number into this box. Up to ten characters
may be keyed in. Do not use "," (comma) and " "
(space).
If the Auto Increment check box is checked and the
Data Number has “-nn” at its end (n : numerals, for
example “Hitachi-00” ), Data Number is incremented
with each successive photographing.
(1-4) Back Ground Image checkbox
When this box is checked, the data display is overlaid
on the scanning image. If it is not checked, the
background of the data display area is black.
(1-5) Embed into Image checkbox
When this box is checked, the auto data display is
embedded into the image data when the image is
saved to disk. If it is not checked, only the image data
is saved. This Setting is also applied for Print, Copy and PCI Transfer commands.
If the For Photograph is checked, the position of the auto data display in the saved
image is shifted slightly upward to ensure that it is properly framed in photographs. It
is recommended not to check the box if the saved image data will be used on the
computer only.
(2) PHOTO SPEED block
(2-1) Direct Photo
Selects a scanning speed for direct photo recording. The number of lines for the
selected scanning speed is shown under the box.
(2-1) Memory Photo
Selects number of scanning lines for memory photo recording.
Normal:
For 640×480 pixels image data
→960 lines (16/19 s photographing time)
For 1280×960 pixels image data
→960 lines (16/19 s photographing time)
For 2560×1920 pixels image data
→1920 lines (32/38 s photographing time)
Enhance: