Instruction manual

3 - 28
3.5.2 Selecting Magnification
There are several ways to select a magnification.
(1) Dragging the mouse in the Magnification indication area on the control panel.
To increase magnification, drag the mouse to the right. To decrease magnification, drag the
mouse to the left. For coarse changes, press the right button and for fine changes, the left
button.
(2) Clicking the mouse button in the Magnification indication area
Magnification increases in incremental steps by clicking the right button and decreases by
clicking the left button.
(3) Click Preset button. The three preset magnifications are toggled through with each click of the
left mouse button.
To set preset magnifications, open the Image tab of the Setup dialog window and input a
desired value in the three Preset Magnification boxes.
(4) Using Low Mag mode
To observe images at low magnifications of a few hundred times or lower, click H/L button. In
Low Mag mode, a mark LM is indicated in the Magnification indication area. To return to High
Mag mode, click H/L button again.
NOTICE: If the preset magnification is lower than the possible minimum magnification for
present WD value, magnification is set at the minimum value by Preset operation.