Instruction manual

3-104

(2) Operation Panel tab

The arrangement of control blocks to be placed on the operation panel can be customized.

(3) Tool bar Setting tab

Select tool buttons to place on the tool button section of the

operation panel.

Tool buttons put check mark are shown on the tool button

section.

(4) Stage tab

(a) MOTOR DRIVE STAGE

Selects enable (On) or disable (Off) for motor driven

stage (5 axes motorized stage of type II or 2 axes

motor drive option of type I instrument). Set it at Off

when the motorized stage is removed or not used, for

example when using the cryo-stage. It is necessary

because control program accesses motor drive part

and may locked up if there is no response from the

motorized stage.

(b) REVERSE MODE

Changes direction of image motion by mouse

operation on the scanning image and by the trackball.

When it is not checked, image moves to the direction

of mouse movement or trackball rotation. When it is

checked, image moves to reverse direction.

When this box is checked, stage driving speed by the trackball or the joystick option can

be adjusted with the Speed slider on the Stage tab on the operation panel.

(5) MOUSE OPERATION tab

Set the sensitivity of mouse operation (focus, stigma.

brightness and contrast adjustment) on the scanning image.

Set a slider control at the Slow side for lower sensitivity or

at the Fast side for higher sensitivity. Adjustable range is a

half to 1.5 times of default sensitivity.

The IMAGE ADJUSTMENT area selects mouse operation

functions to be enabled. Check to use the control