Operator's Manual Original Operating Instructions Walk-Behind Edger WE43 Series WE43 (manual start) WE43E (electric start) Includes models: WE43 WE43E Get parts online at www.getearthquake.com P/N: OmWE43E Rev.
Operator's Manual WE43 Series Walk-Behind Edger INTRODUCTION Congratulations on your investment in quality. Thank you for purchasing a walk-behind edger from Earthquake®. We have worked to ensure that the edger meets the highest standards for usability and durability. With proper care, your edger will provide many years of service. Please read this entire manual before installation and use.
Operator's Manual WE43 Series Walk-Behind Edger Warnings and Safety Precautions Operator’s RESPONSIBILITY Accurate assembly and safe and effective use of the machine is the operator’s responsibility. • Read and follow all safety instructions. • Carefully follow all assembly instructions. • Maintain the machine according to directions and schedule included in this Earthquake® operator’s manual. • Ensure that anyone who uses the machine is familiar with all controls and safety precautions.
Operator's Manual WE43 Series Walk-Behind Edger General Safety Rules • • • • • • • • • • • • • • • • 4 Read, understand, and follow all instructions on the machine and in the manual(s). Be thoroughly familiar with the controls and the proper use of the machine before starting. Use this equipment for its intended purpose only. Familiarize yourself with all of the safety and operating decals on this equipment and on any of its attachments or accessories.
Operator's Manual WE43 Series Walk-Behind Edger Engine Safety Precautions Warning Warning Carbon Monoxide Poisoning Engines give off carbon monoxide, an odorless, colorless, poisonous gas. Carbon monoxide may be present even if you do not smell or see any engine exhaust. Breathing carbon monoxide can cause nausea, fainting or death, in addition to drowsiness, dizziness and confusion. Engines give off carbon monoxide, an odorless, colorless, poisonous gas.
Operator's Manual WE43 Series Walk-Behind Edger • • • • • • During storage, screw down fuel cap vent screw tightly. Never pour fuel from engine fuel tank. Never siphon fuel by mouth to drain fuel tank. Always have an adult fill the fuel tank and never allow children to fill the engine. Never allow an adult or anyone under the influence of drugs or alcohol to fill engine.
Operator's Manual WE43 Series Walk-Behind Edger SAFETY DECALS This edger has been designed and manufactured to provide you with the safety and reliability you would expect from an industry leader in outdoor power equipment manufacturing. Reading this manual and the safety instructions it contains will provide you with the necessary basic knowledge to operate this equipment safely and effectively.
Operator's Manual WE43 Series Walk-Behind Edger ASSEMBLY WARNING UNPACK EDGER 1. Set aside the operator’s manual and parts bag. Carefully lift the edger out of the box, remove any packing material and cut any ties holding the handlebar pieces to the edger assembly. ASSEMBLY 1. Stand the edger assembly upright with wheels on a level surface. DO NOT place the edger on a high surface where it can fall and cause property damage or personal injury. 2. Unscrew knob from height adjustment bar.
Operator's Manual WE43 Series Walk-Behind Edger OPERATION CAUTION Preparing Engine for Starting Never store engine with fuel in the tank indoors. Fuel and fuel vapors are highly flammable. Gas and Oil Quality To operate the engine, we recommend using Viper® brand twocycle oil (P/N 300400) to ensure that the engine operates correctly throughout the life of the engine. Use unleaded regular gas only. Never mix fuel and oil directly in engine fuel tank.
Operator's Manual WE43 Series Walk-Behind Edger Operation TIPS 1. The clutch will transfer maximum power after about two hours of normal operation. During this break-in period clutch slippage may occur. The clutch should be kept free of oil and other moisture for efficient operation. 2. Edge without placing excessive body weight on the unit. The edger operates most efficiently with the weight of the unit itself. 3. Never run engine indoors. Exhaust fumes are deadly.
Operator's Manual WE43 Series Walk-Behind Edger Warm Engine Start: 1. Move choke lever to CHOKE position. NOTE: Choke position is defined by moving the choke lever as far to the CHOKE position as possible. 2. Continue with Step 4 of Cold Engine Starting. Hot Engine Start: 1. Continue with Step 4 of Cold Engine Starting. 2. If engine does not fire, refer to Step 1 of Warm Engine Starting. For model We43e Electric Start 1.
Operator's Manual WE43 Series Walk-Behind Edger MAINTENANCE and Storage STEPS FOR WORKING ON equipment 1. Turn off engine switch. 2. Disconnect the spark plug wire from the spark plug. 3. Securely place the disconnected spark plug wire away from the spark plug and any metal parts. This must always be done or arcing may occur between spark plug wire and metal parts. 4. Replace or repair the part on the edger. 5.
Operator's Manual WE43 Series Walk-Behind Edger Cooling Fins Cooling fins, air inlets and linkages must be free from any debris before each use. CAUTION Air Filter To avoid injury or death, never siphon fuel by mouth. Never run engine without air cleaner properly installed. Added wear and engine failure may occur if air cleaner is not installed on engine. Never store engine with fuel in the tank inside a building. Potential sparks may be present for ignition of fuel and fuel vapors.
Operator's Manual WE43 Series Walk-Behind Edger TROUBLESHOOTING and repair At Earthquake®, we build quality and durability into the design of our products; but no amount of careful design by us, and careful maintenance by you, can guarantee a repair-free life for your Earthquake® Edger. Most repairs will be minor, and easily fixed by following the suggestions in the troubleshooting guide in this section. The troubleshooting guide will help you pinpoint the causes of common problems and identify remedies.
Operator's Manual WE43 Series Walk-Behind Edger TROUBLESHOOTING Guide Problem Possible cause Remedy/Action Engine will not start 1. Power switch off 1. Flip switch to on position 2. Spark plug wire disconnected 2. Connect spark plug wire to spark plug 3. Out of fuel 3. Refuel 4. Spark plug wet, faulty or improperly gapped 4. Clean, replace or gap spark plug 5. Throttle control not held open 5. Hold throttle control open when pulling recoil handle 6.
Operator's Manual WE43 Series Walk-Behind Edger Parts Breakdown WE43E HANDLEBAR PARTS LIST 3 (2) 24 21 16 17 18 4 (2) 5 (2) 6 (2) 22 20 23 14 6 (2) 26 (2) 10 19 4 (2) 5 (2) 8 1 (2) 1 kEY Part # Description Qty.
Operator's Manual WE43 Series Walk-Behind Edger WE43E Main Parts Explosion KEY 2 9 5 14 15 13 12 7 3 8 20 6 Part # Description 1 4634 WHEEL Qty. 3 2 4656 BATTERY BOX 1 3 4657 COVER, BATTERY BOX 1 4 4687 BOLT M10 X 1.
Operator's Manual WE43 Series Walk-Behind Edger WE43 HANDLEBAR PARTS Explosion 1 (2) 14 11 6 7 8 2 (2) 3 (2) 4 (2) 12 10 13 5 4 (2) 9 2 (2) 3 (2) kEY Part # Description 18 Qty. KEY Part # Description Qty. 1 4639 Handle Grip 2 9 400008 HANDLEBAR LOWER 1 2 4640 Nut, T-Handle 4 10 4800 THROTTLE HOUSING 1 3 4641 Washer 4 11 4803 CLEVIS PIN, .188 DIA. GROOVED 1 4 4642 Bolt, Handle Clamp 4 12 4804 E- CLIP, RETAINING RING FOR .
Operator's Manual WE43 Series Walk-Behind Edger WE43 Main Parts Explosion KEY 6 11 12 10 4 9 Part # Description Qty. 1 4634 WHEEL 3 2 4687 BOLT M10 X 1.
Operator's Manual WE43 Series Walk-Behind Edger ENGINE PARTS Explosion 37 37 12 13 11 10 52 49 27 50 53 42 34 33 43 49 50 27 41 25 26 29 28 51 24 38 23 20 35 16 36 14 1 3 6 7 8 9 37 20 30 31 39 32 38 22 16 17 18 36 19 44 46 47 48 45 15 21 37 40 37 2 3 4 6 7 8 37 Check for parts online at www.getearthquake.
Operator's Manual WE43 Series Walk-Behind Edger ENGINE PARTS LIST KEY PART # DESCRIPTION QTY. KEY PART # DESCRIPTION QTY. 1 300484 MAGNETO FLYWHEEL 1 28 3004150* NUT, NYLOC, CHOKE LEVER 1 2 300337 FLANGE NUT M8 1 29 3004150* CHOKE LEVER 1 3 300462 ROTOR WASHER 2 30 3004150* BASE, AIR FILTER 1 CLUTCH ROTOR ASSEMBLY W/Spring 4 300413 5 -- 1 31 3004150* CHOKE PADDLE -- 32 3004150* WASHER,CHOKE LEVER 2 6 300449 SPRING WASHER 2 33 400039 PRIMER LINE HOSE 10.
Operator's Manual WE43 Series Walk-Behind Edger wE43e AND WE43 EDGER Warranty Terms and Conditions Product Warranty: 1-Year Limited Warranty Ardisam, Inc., a manufacturing company, warrants this product to be free from defects in the material or workmanship for a period of one year from the date of purchase. During the one-year warranty of this product, Ardisam will, at their discretion, furnish parts and/or labor to correct any defect caused by faulty material or workmanship.
Operator's Manual WE43 Series Walk-Behind Edger Explanation of Emissions Control Warranty Provisions VIper® Engines are designed, built and equipped to meet all EPA requirements. It warrants that it is free from defects in material and workmanship that could cause failure to the warranted part; and that it is identical in all material respects to the engine described in the manufacturer's application for certification.
Earthquake™, Division of Ardisam, Inc. 1160 8th Avenue, PO Box 666 Cumberland, WI 54829 800-345-6007 | Fax 715-822-2223 E-mail: info@ardisam.com All weights, specifications and features are approximate and are subject to change without notice. Due to continuous product improvements, product images may not be exact. Items used for props not included. Some assembly may be required. Check for parts online at www.getearthquake.
