User Manual

The Dispatch Master is a digital delay
and reverb unit with an all analog direct
signal path and true bypass switching. It is
capable of producing nearly 2 seconds
of delay time with near-infinite repeats
and a cavernous reverb. Both effects
can be run separately or in unison.
Controls
Time: Controls the delay time, from 0ms
to nearly 2000ms
Repeats: Controls the regeneration
of the delayed signal. Also acts as a
enhancer for the reverb. In reverb mode
this will control the thickness, decay,
depth and overall nature of the reverb.
Reverb: Controls the reverb mix
Mix: Controls the over all level of the
effected signal
To use as a reverb only, turn the time
control all the way down and adjust the
reverb and mix controls to taste. In this
mode, the repeats control can be used
to enhance the thickness, decay, depth
and overall nature of the reverb. With the
reverb control at it’s maximum setting,
the repeats control will gradually over-
load the effect at higher settings.
To use as a delay only, turn the reverb
control all the way down and adjust the
time, repeats and mix controls to taste.
To use both effects in unison, adjust all
controls to taste.
Power
A standard regulated 9-volt DC power
supply with a negative center 2.1mm
barrel. We do not recommend any
adapter that isn’t designed for musical
instruments. Do not run at higher volt-
ages! Does not use batteries. Current
draw is around 100ma.
For best results, place after dirt pedals
and other modulation and before any
signal boosters.
See EarthQuakerDevices.com for war-
ranty information or write: EQDevices
@
yahoo.com.
© 2011 EarthQuaker Devices LLC.
www.earthquakerdevices.com
Dispatch Master