User`s manual

ENGLISH

Chapter 2 — Getting Started

Note: Use only 1-inch DDR SODIMM (200 pin) modules.

Removing a Memory Card

1. Turn off the computer and disconnect the AC adapter. Turn the

computer upside down and lay it on a flat surface.

2. Carefully remove the two RAM compartment cover screws and

remove the RAM compartment cover.

3. Gently pull tabbed latched in the direction of the arrows (1). The

card will pop up slightly.

4. Pull upwards on the card and then slide the card out (2).

Inserting a Memory Card

1. Hold the memory card by its edges with the edge-connector

side towards the slot.

2. Hold the card at a shallow angle (about 25 degrees) and insert

the edge connector into the connector slot (3). The “gold teeth”

of the edge connector should no longer be visible when the

card is fully inserted.