Instructions / Assembly

P95024_P95048_M52135_Rev_Nov2019

PAGE 1

ASSEMBLY

PROFESSIONAL

SNOW PUSHER

24”, 30”, 36” & 48” ASSEMBLY INSTRUCTIONS

Attach pusher blade to pusher support

by inserting

into center hole at top

of blade. Thread nut onto bolt but do

not tighten. Insert all hex nuts into back

of pusher support.

Grasp pusher blade support by shaft,

ex blade to insert second

into

middle hole at center of blade.

HARDWARE

Stainless Steel

1/4” Hex nut (4)

Lynch pin (1)

Stainless Steel

1/4” x 20 Bolt (4)

Stainless Steel

#8 5/8” Phillips

screw (2)

PAGE 1
PROFESSIONAL SNOW PUSHER 24”, 30”, 36” & 48” HARDWARE 1a Lynch pin (1) 1b Stainless Steel 1/4” Hex nut (4) 1c Stainless Steel 1d Stainless Steel ASSEMBLY INSTRUCTIONS ASSEMBLY 1 Attach pusher blade to pusher support by inserting 1c into center hole at top of blade. Thread nut onto bolt but do not tighten. Insert all hex nuts into back of pusher support.
PAGE 2
ASSEMBLY 3 Insert LH and RH bolts 1c through remaining blade holes TIGHTEN ALL BOLTS, USE NEEDLE NOSE PLIERS TO TIGHTEN NUT FROM STEP 1. 4 Insert handle shaft into pusher support 5 Open 1a lynch pin and insert through hole at top of pusher support. Insert from back of support towards front (specifically designed to be snug in this direction). 6 Install remaining two screws 1d into lower two holes of pusher support.
PAGE 3
PARTS LIST 99003 PUSHER SUPPORT 38002 HARDWARE PACK (QTY 1) (QTY 4) (QTY 4) (QTY 2) 99002 FIBERGLASS HANDLE SHAFT PUSHER BLADE 99001 D-HANDLE 99050 99051 24” SHOVEL BLADE 30” SHOVEL BLADE 99052 99053 36” SHOVEL BLADE 48” SHOVEL BLADE CUSTOMER SERVICE 574.848.7491 | SUPPORT@EARTHWAY.COM | WWW.EARTHWAY.COM 1-YEAR LIMITED WARRANTY EarthWay Products, Inc.