Full Product Manual

ASSEMBLY/OPERATION
ON/OFF SWITCH/SPEED CONTROL
For extra control, model BLR20075 is fitted with a two speed
switch located on the handle of the power head.
The switch has three positions: “O”, “1” and “2”.
Position “O” is off. To use in low speed, move the switch to
the center position “1”. To change to high speed, move the
switch to position “2”.
To turn the tool ON, slide the switch to position “1” or position
“2”, depending on the desired speed.
To turn the tool “OFF”, slide the switch to the “O” position.
Hold the blower tube approximately 7
inches above the ground, switch your
product on and using a sweeping
motion from side to side, advance
slowly. Keep the accumulated debris/
leaves in front of you.
CAUTION: The blower can throw
debris, possibly causing serious
personal injury to the operator or
bystanders.
Use your product only in daylight or good artificial light.
The blower is intended for residential use only. Use the blower
outdoors to move debris as needed.
WARNING: Always wear safety glasses to prevent debris
from being blown into eyes and face, which can cause serious
injury.
Do not blow hard objects such as nails, bolts, or rocks.
Do not operate the blower near bystanders or pets
Use extra care when cleaning debris from stairs or the tight
areas.
When not in use, store the blower and extension cord indoors,
in a cool dry place.
“1”= LOW
“2”= HIGH
“O”= OFF
If you drop the unit, carefully inspect it for damage. If the
housing is cracked or handles broken or if you see any
other condition that may affect the unit’s operation, contact
your local Authorized Service Center for repairs before
putting it back into use.
CAUTION: Do not at any time let brake fluids, gasoline,
petroleum based products, penetrating oils, etc., come in
contact with plastic parts. They contain chemicals that can
damage, weaken or destroy plastic.
IMPORTANT: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment should
be performed by a qualified service organization, always
using identical replacement parts.
CAUTION: DO NOT POUR OR SPRAY WATER ON THE
BLOWER TO CLEAN. Never let any liquid get inside the
blower. Never immerse any part of the blower into a liquid.
WARNING: For your safety, turn switch “OFF” and remove
extension cord plug from power source before maintaining
your blower.
Fertilizers and other garden chemicals contain agents
which greatly accelerate the corrosion of metals Do not
store the tool on or adjacent to fertilizers or chemicals.
Make sure the blower is unplugged, then use only mild
soap and a damp cloth to clean the tool. Never let any
liquid get inside the tool; never immerse any part of the
tool into a liquid.
MAINTENANCE
4
Possible Cause
- Extension cord not connected to the plug
- Cord not connected to power source
- Switch not in “ON” position
Possible Solution
- Check extension cord is fully connected to blower
- Check extension cord is fully connected to a receptacle
- Check that switch is in the “ON” position
Problem
- Unit does not run
TROUBLESHOOTING