CONVERTIBLE 2 IN 1 CVPS41008 CVPS41010 This product / CHAIN SAW
the the saw and/or handles CAUTION: Never use guard as a handle. Never grasp the unit by the guard. Failure to heed this warning can result in serious personal injury. chain saws.
distance WARNING: California Proposition 65: This product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Fig. 1 Chain saw w/chain and bar Telescoping pole Fig. 2 CONVERTING FROM POLE SAW TO CHAIN SAW. The electric chainsaw is a separate operating unit when not assembled to the telescopic pole. POLE ASSEMBLY: Remove rubber caps from the upper and lower pole sections. Hold the two sections of the pole as shown with the arrows facing up.
INSTALLING/REPLACING THE GUIDE BAR AND CHAIN 4
INSTALLING/REPLACING THE GUIDE BAR AND CHAIN 5
LEFT HAND CUTTERS RIGHT HAND CUTTERS CORRECT TOP PLATE INCORRECT TOP PLATE FILING ANGLE FILING ANGLE LESS THAN 30 30 CORRECT SIDE PLATE FILING ANGLE MORE THAN 30 INCORRECT SIDE PLATE FILING ANGLE HOOK 80 BACKWARD SLOPE CUTTING CORNER SIDE PLATE DEPTH GAUGE TOP PLATE RIVET HOLE HEEL RAKER CLEARANCE .025 in. (0.
DO NOT PULL the trigger until you are ready to make a cut. When using the chain saw place your right hand on the rear handle and your left hand on the front handle with your thumbs and fingers encircling the chain saw handles. A firm grip together with a stiff left arm will help you maintain control of the saw if kickback occurs. When using as a pole saw place WARNING: Be aware of the cord while operating the saw. Keep the cord away from the chain. Be careful not to trip over the extension cord.
and/or handles When using the chain saw place your right hand on the rear handle and your left hand on the front handle with your thumbs and fingers encircling the chain saw handles. When using as a pole saw place PLANNED LINE OF FALL PLANNED 135 LINE OF FALL SAFE RETREAT ZONE 45 90 135 when using pole saw. gripping Do not use the pole saw to fell saplings. Use the chain saw without the pole attachment. in the "off " position.
PRUNING LIMBING 2nd Cut-Pruning Cut(to avoid pinching) 4th CutFinal Stub Cut 1st Cut-Pruning Undercut(to avoid splintering) 3rd Cut-Stub Undercut (to avoid splintering) Make first cut six inches from tree trunk on underside of limb. Use top of guide bar to make this cut. (Cut 1/3 through diameter of limb.) Move two to four inches farther out on limb. Make second cut from above limb. Continue cut until you cut limb off. Make third cut as close to tree trunk as possible on underside of limb stub.
and chain oil, Reverse chain so that cutters face the right direction 10
CVPS41010 CVPS41008 2.75m (9 ft) 2.