Installation & Assembly

IMPORTANT: During Installation, immediately wipe any adhesive from the floor surface.
Part II MAINTENANCE & CARE
Finishing & Maintenance:
You can hide the small holes left by finishing nails with wood putty.
1. Fill the hole.
2. Wipe excess wood putty immediately with a clean cloth and cleaner.
3. Apply a thin coat of urethane to the clean surface of the putty.
4. Let it dry for about 1 hour.
Regular Maintenance:
 Clean your wood floors with a damp cloth or terrycloth mop/applicator. Wipe in the direction of
the grain (length of the boards).
 Waxing is NOT recommended. Dust mop or vacuum your wood floor as needed. Never wet-mop
or flood your floor with water.
 Never use cleaners that contain oil soaps or surfactants.
 Set up precautions and a regular maintenance program depending on your specific traffic
conditions.
Preventive Maintenance:
 Install floor protectors on all furniture legs, especially if the piece has the potential of moving on the
wood. Make sure you use the correct size and pad thickness for the weight and size of the furniture.
Once the entire surface is covered, remove
the expansion spacers to install molding to
cover the expansion joint.
Complete installation with moldings.
Do Not walk or place any personal
belongings on newly installed floor for at
least 24 hours, this will enable Adhesive to
properly cure.