Installation & Assembly

8
Proceed from left to right to install other planks
in the rows.
Do small sections to ensure adhesive does not
dry before the planks are laid.
Use knocking block and pull bar to fasten the
joint.
As you work, immediately clean any adhesive
from the wood surface
Start subsequent row using the remainder of the
cut-off end plank from previous row. The remainder
should be at least 6”.
Insert the tongue end into the groove and lower the
plank as close as possible to the adjacent one,
avoiding contact with the adhesive as much as
possible.
For best results, stagger the joints 6" (150 mm) to
8" (200 mm) from the previous row and alternate
board length.
Use 100-150 lb. roller to apply pressure to installed
sections while the adhesive is still active
(approximately 45-60 min).
Remove all dust and debris prior to rolling.
Once the entire surface is covered, remove the
guide planks and replace with flooring plank.
Remove the expansion spacer to install molding to
cover the expansion joint.
Complete installation with moldings.
Do Not walk or place any personal belongings on
newly installed floor for at least 24 hours, this will
enable Adhesive to properly cure.