Warranty Guide

 Plank on the last row and the first row must be in
a minimum width of 2” (50mm).
 Remember to include expansion gap of ½” from
the wall.
 Cut the plank lengthwise and glue the short
ends.
 Complete installation with moldings. Any
molding must be fixed to the wall, never to the
floor.
Disassembling (without the use of tools):
EZ click floor planks can be easily disassembled by proper method. This allows for replacement
during installation and also during use.
 Separate the whole row by carefully lifting up
and slightly knocking just above the joint.
 Fold up and release the whole long-side.
 Disassemble the panels by sliding horizontally
(from side to side).
 Do not fold up.
Radiator Pipes
 Installation at radiators: Drill the holes 1” larger
than the diameter of the pipes.
 Horizontal installation: Cut off the locking
element with a hand saw and push the planks
horizontally together. If necessary, place some
spacers between the last panel and the wall to
keep the planks together during the curing time
of the glue.