Specifications

166119 8/31/2006
48
The following diagram depicts the menu/options tree for the Channel Configuration Menu:
Local Channel
Configuration
1
Remote Channel
Configuration
2
Channel
Restoral Timer
9
Channel
Failover Rate
8
[1]- Loops Off
[2]- Local Loopback
[3]- Remote Loopback
[4]- Both Loops On
Channel
Loop Modes
10
Channel
Failover Mode
7
[1]- HI Priority (not bumpable, will seek backup)
[2]- Low Priority (bumpable, will seek backup)
[3]- Fixed High (not bumpable, will not seek backup)
[4]- Fixed Low (bumpable, will not seek backup)
Channel
Port DCD
Source
6
[1]- Follows Composite Sync State
[2]- Follows Far-end RTS
Channel
Port RTS/CTS
Delay
5
[1]- TxC
[2]- TxCE
Channel
Port TxD Clock
Signal
4
Channel
Port Type
3
[1]- RS232, Async 8-bit
[2]- RS232, Async 9-bit
[3]- RS232, Async 10-bit
[4]- RS232, Async 11-bit
[5]- RS232 Synchronous
[6]- EIA-530 / X.21, Sync (Channels 1,5,9,13 only)
[7]- V.35 Synchronous (Channels 1,5,9,13 only)
Channel
Port Rate
2
Channel
State
1
Channel
Configuration
3
Channel
#
Select
Channel
Channel
Selection
1-16
Clone this
Channel Config.
from another
12
[1]- Unsuspend Channel
[2]- Allocate Channel on Composite Link A
[3]- Allocate Channel on Composite Link B
[4]- Suspend Channel
[5]- Take Channel Out of Service
[1]- None
[2]- 3 mS Delay
[3]- 7 mS Delay
[4]- 13 mS Delay
[5]- 26 mS Delay
[6]- 53 mS Delay
[7]- CTS Off
[8]- CTS On
Select
Channel
[1]- Manual
[2]- Immediate
[3]- 5 seconds
[4]- 10 seconds
[5]- 20 seconds
[6]- 30 seconds
[7]- 60 seconds
[8]- 5 minutes
[9]- 15 minutes
[10]- 30 minutes
[11]- 1 hour
(Options same as
Channel Port Rate
Menu above)
[1]- 1200 bps
[2]- 2400 bps
[3]- 4800 bps
[4]- 7200 bps
[5]- 9600 bps
[6]- 14.4 Kbps
[7]- 16.0 Kbps
[8]- 19.2 Kbps
[9]- 24.0 Kbps
[10]- 28.8 Kbps
[11]- 32.0 Kbps
[12]- 38.4 Kbps
[13]- 40.0 Kbps
[14]- 48.0 Kbps
[15]- 56.0 Kbps
[16]- 64.0 Kbps
Figure 23
In this menu the operator begins by first choosing whether to operate on Local channel
parameters, or Remote channel parameters. This is important when dealing with port-specific