Manual

Phone:

609-752-0321

Fax: 609-752-0320

562 Route 539

Cream Ridge, NJ

08514

EAST COAST

SUPERCHARGING

ECS Halfshaft

Loop

Instructions

Kit Contents:

 (2) Steel U Bends

 (2) Main Mounting Brackets

 (2) Lower Mounting Brackets

 (2) 7/16 x 3 ¾ Bolts

 (4) 7/16 x 2 ¾ Bolts

 (2) 7/16 Lock Washers

 (8) 7/16 Flat Washers

 (2) 7/16 Lock Nuts

 (1) Tube Blue Loctite

PAGE 1
ECS Halfshaft Loop Instructions V1 EAST COAST SUPERCHARGING Kit Contents: 562 Route 539 Cream Ridge, NJ 08514 Phone: 609-752-0321 Fax: 609-752-0320    (2) Steel U Bends (2) Main Mounting Brackets (2) Lower Mounting Brackets  (2) 7/16 x 3 ¾ Bolts  (4) 7/16 x 2 ¾ Bolts  (2) 7/16 Lock Washers (8) 7/16 Flat Washers    (2) 7/16 Lock Nuts (1) Tube Blue Loctite
PAGE 2
Installation Instructions: 1. Unpack the ECS driveshaft loop kit and check contents. 2. Remove the steel U bends from the main mounting brackets 3. Mark left and right leaf spring bolts with a black line. (Fig 1) 4. Loosen leaf spring bolt while counting the number of turns. Write the number down. The leaf spring will lower away from the control arm making room for the installation. Fig 1 5. Apply a few drops of threadlocker to the 7/16 x 2 3/4 bolts. 6.
PAGE 3
10. Make sure the bracket is centered on the CV shaft and tighten both of the 7/16 bolts. 11. Slide the U bend over the CV shaft and insert the 7/16 x 3 ¾ bolt with supplied flat washers and locknuts into the main bracket. (Fig 5) Fig 4 12. Tighten the U bend bolt. 13 . Retighten the leaf spring bolts by turning the bolt the same number of turns that were loosened in step 4. Fig 5 Thank you purchasing the ECS Halfshaft Loop Kit. Any questions feel free to call the shop at 609-752-0321.