User Manual

EASTCOASTSUPERCHARGING.COM
n
609-752-0321
n
15
n
n
For ECS balancer installation, remove and
discard stock balancer bolt, if using impact
gun take care not to damage the radiator
as the bolt backs out. Then properly locate
the balancer pulley over the stock balancer
while making sure the locating tabs sit
properly as shown in the pictures above.
n
Next, place small amount of red loc-tite
on new supplied balancer bolt and hand-
tighten. While still loose, turn the balancer
counter-clockwise to make sure locating
tabs are locked into place. The balancer
should only move a few degrees. Proceed to
torque down the balancer bolt to spec.