Manual

• Congratulations. Rack is out of the car and you are ready to
pin the crank. Stop have a beer. (not supplied with kit)
Pinning the Crank
• Remove 24mm stock crank bolt with impact gun.
DISCARD STOCK BOLT!!! DO NOT REUSE!!!
• On a workbench slide ¼ in drill bit through pin
fixture and slightly past crank pin as shown
(fig 27)
• Mark the front side of the drill bit with a
marker to set the depth that you will need to
drill the crank as shown (fig 28)
• Wrap drill bit with a piece of tape at the
marked spot.
• Screw the supplied bolt with the pin fixture into the
crank and snug up.
• Wearing safety glasses, drill pin hole in crank until
tape touches fixture as shown.(pic)
26e
27
28
29
Rack is out of the car and you are ready to pin the crank now.