Manual

• Strap the outside air temperature sensor from
your previously removed radiator shroud.
Reattach utilizing provided zip tie to forward,
passenger side leg of the radiator support cradle
as pictured. (fig 48)
• On the lower, passenger side of the radiator support
cradle, locate horn wires and plug. Approximately 1
¼ inches up from plug cut wires as shown. Be sure to
leave enough room to attach supplied horn extension
wires and butt connectors. Unwrap wires, and strip
ends on both sides. Attach corresponding color wires
via butt connectors to horn wiring harness and plug
end as pictured. (fig 49) Cover with supplied wire
loom, and tape if desired.
• Using supplied horn spacer, and ¼ x 2 ½
bolt, remount horn in previously prepared
mounted rivet nut on front leg of radiator
support cradle (passenger side). Horns
should be oriented vertically (up between
frame rail and light bucket) as shown to
avoid damage from any road debris or
water. (fig 50)
• Towards the back of the passenger side, rear leg of
the radiator support cradle, there is a hole from the
factory that is approximately a ¼ in diameter. Drill
this hole out with the supplied Q drill pit. Insert rivet
nut following same instructions as above. This
location is used to support the lower intercooler
charge tube (fig 51).
48
49
50
51
Relocate the outside air temperature sensor from your
previous removed radiator shroud. Reattach to plastic air
dam shroud located right in front of the radiator cradle as
shown in picture 48.
48
To relocate the horns, after extending the
wires, move horn assembly to berglass shelf
right below headlight by drilling a 1/4” hole
and using the factory bolt with the supplied
nut, as shown in picture 50.
50