Manual

• Install 2

head unit spacer on the previously

installed lower passenger side 3/8ths bolt as

shown. (fig 63)

• Install the two remaining 3/8ths studs and head

unit spacers to head unit and mounting bracket

with supplied washers and lock nuts as shown.

(fig 64)

• Tighten ALL Head unit/bracket hardware.

• On top of head unit, remove top plug and install the

head unit vent with a 3/16ths allen wrench.

• Your head unit was pre-filled from the factory, but take

a moment to check for proper oil level by removing the

dipstick – located on the passenger side of the head

unit right below the vent plug. (fig 64 see arrows)

•

• Install the passenger side upper radiator support

bracket with the 10mm factory radiator support

bolts. (fig 65)

• Reinstall alternator with factory hardware (15mm

socket), being sure to reinstall electrical plug and

main power feed on back of alternator (13mm

nut).