Manual

• Remove two screw tabs from previously removed
lower front air shroud as shown (fig 72), and install
on leading edge of front inner fender liners.(fig 73)
Secure drivers side with factory 7mm bolt.
• Trim passenger side inner fender well clear
charge tube. Reinstall factory brake duct and
brake duct housing during reinstallation;
securing with factory 7mm bolts. (fig 74)
• Measure overhang of front facia to radiator support
cross bar. No more than an inch or 1 ½ inches
should need to be trimmed. Trim excess with air
saw or razor knife and straight edge. (fig 75)
72
73
74
75