User's Manual

1200DPI. Press the switch button at bottom of Mouse can easy to adjust DPI(check
picture for the button). LED indicator( will flash one time while it converting to
800DPI, LED will flash twice while it converting to 1200DPI, LED will flash three times
while it converting to 1600CPI,4 times for 2400DPI,5 times for 3200DPI,6 times for
4800DPI.
2. Polling rate adjustment
3 polling rate 125Hz/250Hz/500HZ can be adjust, default as 500HZ.
3. Saving power mode and power switch off
If mouse is stay out of work for 8 minutes, it will turn to power saving mode, press any
button to restart it.
If you turn off PC or take out Nano receiver from USB port, press any button or move the
mouse to enter the power saving mode.
4, Power on/Off button at mouse bottom
The backlight can be off for economy mode.
5, Nano receiver
A very small size design for Nano receiver, it can be plug and stay on USB port of
PC/Notebook without interference.
Portable design for travel, Nano receiver can be plug into the slot next to the battery
position.
6. Customized button function
The button function can be set by software(Left key is not available )
Reconnection
Both of mouse and Nano receiver has a built-in code, It can be setting one mouse to
one receiver, or few of mouse to one receiver. Mouse and receiver need to reconnect
under the condition of High temperature, high magnetic, strong vibrate.
1. Plug off the Nano receiver from USB port, and plug it on
2. Move RF mouse within 50CM to Nano receiver, re-install the battery, Press any key
to reconnect, the above operation must be completed in 15 seconds.
3. Mouse will ready to work after reconnection.