Eastern Tools & Equipment, Inc TG72B12 Portable Generator 8250 Surge Watts 7250 Continuous Watts Customer Service (888)-908-6200 www.easterntools.com Eastern Tools & Equipment. Inc Ontario, CA U.S.
Thank you for purchasing products from EASTERNTOOLS & EQUIPMENT, INC. We appreciate your business. The following manual is only a guide to assist you and is not a complete or comprehensive manual of all aspects of maintaining and repairing your generator. The equipment you have purchased is a complex piece of machinery. We recommend that that you consult with a dealer if you have doubts or concerns as to your experience or ability to properly maintain or repair your equipment.
Safety Warning Please read this manual to understand how to use your unit as well as understanding the risk the come with the unit. ELECTRIC SHOCK AND SHORT CIRCUIT Be sure to notify the utility company when using the generator for backup NOTICE exceeding your generator wattage/ power. Use approved transfer amperage coverage capacity can damage your equipment to isolate the generator from electric unit as well as any devices attached to your unit. utility.
Keep the same concept when disconnecting electrical devices; make sure all devices are in the "OFF" position before disconnecting. 2. Allow the oil to drain completely. 3. Replace the drain plug. 4. Remove oil fill cap/dipstick to add oil. 5. Add 33.8 oz (1 L) of oil and replace oil fill cap/dipstick. Operate the generator on level surfaces only. Inclined surfaces reduce the effective lubrication 6. Dispose of used oil at an approved waste management facility. of the engine.
Controls and Features Read this owner’s manual before operating your generator. Familiarize yourself with the location and function of the controls and features. Save this manual for future reference.
Order No. 1 Name Air-cooled generator set Tool Kit: Qty 1 Flat Head Screwdriver Spark Plug Wrench 2 1 Wrench, 8×10,17×19 Battery Wire Assembly Kit: 3 Wheel (2 pcs) 1 Wheel Kit Hardware 1 Generator Foot (2 pcs) 1 Handle 1 Assembly Kit: 4 Assembly Kit: 5 etc.
2. CONNECTING THE BATTERY'S CATHODE: AUTO THROTTLE CONTROL SWITCH When using the generator, leave the AUTO THROTTLE CONTROL SWITCH (ATC) in the “ON” position; as soon as output is not needed. The engine will go into idle speed thus saving fuel. As soon as, power is need again the engine will operate as normal again. a. Connect one end of the white cable to the (negative) " - " end and fasten it. Battery cable installation instructions: 1. CONNECTING THE BATTERY'S ANODE b.
STARTING THE UNIT MAINTENANCE Please refer to your start up guide that comes with your unit. Generator maintenance consists of keeping the unit clean and dry. Be sure to store the unit in a clean and dry environment, where it will not be exposed to excessive dust, dirt, moisture or any corrosive vapors. Cooling slots should always be clean and free from clogs.
AIR FILTER Unscrew the bolt from the air cleaner cover, and remove the air cleaner cover. Check the air cleaner element to be sure they are clean and in good condition. L13-30R: 120V, 30Amp Twist Lock Receptacle If the air filter is dirty, remove and clean the element. Wash in solvent Squeeze Soak oil Squeeze dry STORAGE The generator should be started at least once every week. If this cannot be done and you must store the unit more than 30 days, please follow the following guidelines.
MAINTENANCE ·Tighten the oil drain plug and fill the engine with new oil to the filter neck. ·Pull the starter grip carefully until resistance is felt. ·Store the generator in a clean area. Below is a routine maintenance schedule. (1):These items should be serviced by a dealer. (2):Every 3 years.
TROUBLE SHOOTING Problem Generator will not start Cause Solution No Gasoline Add Gasoline Faulty spark plug Replace spark plug Unit loaded during start up Remove load from unit Low oil level Fill crankcase to the proper level Place generator on a flat, level surface Choke in the wrong position. Spark plug wire loose Adjust choke. Generator shuts down during operation Out of Gasoline Refill gasoline Low oil level Fill crankcase to the proper level.
WIRING DIAGRAM 12
Parts List 13
LIMITED WARRANTY Eastern Tools & Equipment, Inc. will repair or replace, free of charge, any part or parts of the generator that are defective in material or workmanship or both. Transportation charges on parts submitted for repair or replacement under this Warranty must be borne by purchaser. This warranty is effective for the time period and subject to the conditions provided for in this policy.
Normal wear: Engines and generators, like all mechanical devices, need periodic parts service and replacement to perform well. Warranty will not cover repair when normal use has exhausted the life of a part of an engine. Improper maintenance: The life of an engine or your equipment depends upon the conditions under which it operates, and the care it receives.
periods of time listed above listed above provided there has been no abuse, neglect or improper maintenance of your small nonroad engine. Your emission control system may include parts such as the carburetor, or fuel-injection system, the ignition system and catalytic converter. Also included may be hoses, belts, connectors and other emission-related assemblies. Where a warrantable condition exists, Eastern Tools & Equipment, Inc.
PRODUCT REGISTRATION For more efficient customer service, please fill out the information below and mail to Eastern Tools & Equipment, Inc. Product Warranty and Registration Division. Model No._________________ Engine Serial No.
