Specifications

7
AUTO THROTTLE CONTROL SWITCH
When using the generator, leave the AUTO
THROTTLE CONTROL SWITCH (ATC) in the “ON”
position; as soon as output is not needed. The
engine will go into idle speed thus saving fuel.
As soon as, power is need again the engine will
operate as normal again.
Battery cable installation instructions:
1. CONNECTING THE BATTERY'S
ANODE
a. Connect one end of the red cable to the
(positive) " + " end and fasten it.
b. After attaching the cable to the anode please
remember to attach the rubber safety over the
anode (as illustrated in this picture).
c. Connect the other end of the red cable to the
output end relay.
2. CONNECTING THE BATTERY'S
CATHODE:
a. Connect one end of the white cable to the
(negative) " - " end and fasten it.
b. After attaching the cable to the cathode.
Please remember to attach the rubber safety
over the cathode (as illustrated in this picture).
c. Connect the other end of the white cable to
the bearing support of the alternator and fasten
it.