User's Guide

Operation and Maintenance
September 30, 2004 7F3319 2-51
Opening the Hood You will have to open the hood to clear film jams in the developer area or to
open the front door manually.
CAUTION
:
Whenever you raise or lower the hood, grasp the hood only
in the area of the recessed slot below the Local Panel to
avoid pinching your fingers.
To open the hood:
1. Remove any films in the output tray.
2. Grasp the hood at the recessed slot below the Local Panel.
3. Raise the hood until the support rod locks into the top slot.
To close the hood:
CAUTION
:
Close the hood carefully. Releasing and dropping the hood
could damage the Laser Imager.
1. Raise the hood slightly and push the rod slightly to the rear from the
slot.
2. Gently lower the hood to the closed position.
Hood Support
Grasp Hood
Rod
Here
Output
Tray