User's Guide

2-52 7F3319 September 30, 2004
Operation and Maintenance
Loading and Removing
Film Cartridges
To load a film cartridge:
1. Open the front door. (See “Opening the Front Door” on page 2-48.)
2. Insert the cartridge into the slot as shown in the illustration.
3. Slide the cartridge fully into the Imager.
4. Close the front door.
After you close the door, the Imager opens the film cartridge. If the
film characteristics are different from the previous cartridge, the
Imager automatically runs a calibration print (see “Calibration Prints”
on page 2-53). The Imager then begins printing jobs from the print
queue.
To remove a film cartridge:
1. Open the front door. (See “Opening the Front Door” on page 2-48.)
2. Lift the edge of the cartridge slightly, then pull the cartridge out of the
Imager.
Loading and Unloading Film
Perforations
to the left