User's Manual

User Guide
2-16
8599110 2001 March Rev. B
Kodak Keypad – Imager Menu
The numbered descriptions correspond to the numbered callouts in Figure 2-11.
1. Attention Message Area – Displays system status and error messages.
2. Contrast, Density, & Count Menu Button – Used to access the Contrast,
Density, & Count Menu.
3. Print Density Test Button – Initiates a density test film print containing a
SMPTE test pattern.
4. Image Polarity Button – Selects positive or negative image polarity.
5. RETURN Button – Used to return to the Main Menu.
6. Image Framing Button – Sets image framing to ON or OFF. When set to ON, a
one pixel frame is printed around each image.
7. Output Button – Selects the desired output destination (Imager 1 or Imager 2).
This button is not displayed if the keypad is connected to a Standard or Plus
system.
8. Image Processing Button – Selects smooth or sharp image processing. (The
choice depends on the personal preference of the viewer.)
9. Print Contrast Test Button – Initiates a contrast test film print. The last image
stored is printed 15 times using 15 different contrast settings. On either an 8700
or 8500 Laser Imager Standard or Plus system, the 15 images may be printed on
a single film sheet or the 15 different contrast images may be printed on multiple
film sheets depending on the acquired image size.