User's Manual

Troubleshooting
4-3
2001 March Rev. B 8599110
Message
Number
Operator Action
P228 Open the left door. Grasp the transport handle and slide the
transport out of the imager, then slide it back in until it latches.
P229 Use the mechanical release to open the supply door (refer to page
4-14).
P301
P302
P303
Turn the imager OFF, wait five seconds, then turn the imager back
ON.
P501
P506
Open and close the top cover of the imager to reset the developer.
P507
P509
P551
P552
P553
P554
Turn the imager OFF, wait five seconds, then turn the imager back
ON.
P561 If this error is caused by a film jam, clearing the jam should clear
the error. If not, turn the imager OFF, wait five seconds, then turn
the imager back ON.
P601
P602
P603
P604
P605
P620
P622
P623
Turn the imager OFF, wait five seconds, then turn the imager back
ON.
P624
P625
P631
P632
P633
P634
Insert a different film cartridge and press Calibration on the local
panel.
P910
P913
Turn the imager OFF, wait five seconds, then turn the imager back
ON.