User's Manual

Troubleshooting
4-7
2001 March Rev. B 8599110
Removing Jams from Area 2a
1. Open the left door (the imager automatically unlocks the door).
2. Squeeze the transport handle and slide the assembly out of the imager.
3. Push in the lever at the bottom of the transport. The film should drop out of the
transport; if not, reach through the access holes and push the film down and out
of the transport.
4. After removing the jam, slide the transport assembly in until it latches (do not
squeeze the transport handle), then close the left door.
Lever
Access Holes
Handle
Figure 4-2. Removing Jams from Area 2a