User Manual
Table Of Contents
- System Power Up and Power Down
- Shut Down
- Using the Touch Screen Local Panel
- Status Screen
- • Film size appears in the upper left corner.
- • Film base type appears in the lower left corner.
- • Current number of film sheets available appears on the right
- Operation
- Opening the Front Door
- Opening the Film Drawers
- Film Drawers and Front Door Manual Override Latches
- Opening the Hood
- Loading Film Cartridges
- 1. At the Door Control or Status screens, touch the desired film drawer icon. The laser imager cl...
- 2. Pull the film drawer out to its furthest extension.
- 3. To remove a film cartridge, hold the edge of the cartridge and lift the cartridge out of the d...
- 4. To load a new or different cartridge, insert the cartridge into the film drawer with the perfo...
- 5. Slide the drawer into the laser imager.
- Recycling Empty Film Cartridges
June 12, 2003 5E6155 3-1
3
Operation and Maintenance
System Power Up and Power Down
Power Up To power up the laser imager, push and hold the power switch to the ON
position for about 2 seconds.
The power up process takes approximately 3 minutes. After power up, the
laser imager begins accepting and queueing print jobs. At this point, you
can determine cartridge status and load new cartridges if necessary.
Film will not begin processing until the laser imager is completely warmed
up (approximately 45 minutes).
Power Switch (press for two seconds)