User Manual

4-22 5E6155 June 12, 2003
Troubleshooting
Exercise caution when removing jammed film from the
processor.
4. Release the two clamps at the left of the processor.
CAUTION
:
Whenever you raise or lower the drum cover, grasp the
cover only on the lift handle to avoid the possibility of
pinching your fingers.
5. Open the drum cover.
CAUTION
:
To prevent damage to the surface of the processor drum, do
not use any type of tool to remove jammed film.
6. Clear the jammed film from the processor area. There may be more
than one sheet.
NOTE: If the film is jammed in the lower section of Area 4, you will need
to open the front door to remove the film (see “Clearing Film
Jams from Area 2” on page 4-19).
7. Close the drum cover and secure it with the two clamps.
8. Close the upper hood.
9. If you cannot clear the jammed film, call Service.
NOTE: The processor has to warm up to operating temperature before
the processor can print.
Clearing Film Jams from
Area 5
The drive rollers prior to the sorter is Area 5. If film stalls in this area, an
error message occurs on the local panel.