User's Manual

Quick Start Up
www.kodak.com/go/support
4
NOTE: If you prefer to use the monitor without the dock, connect the AC adapter with the shorter cord to
the side of the monitor. For increased mobility, you can also use the monitor for up to eight hours
with the rechargeable battery provided.
6 Seat the monitor in the dock. A red light on the dock glows when the monitor is
properly seated.
7 Plug the AC adapter into a standard electrical outlet.
8 Press the On/Off button on the monitor for more than 2 seconds. A light on the top
of the monitor glows when the monitor is turned on.
9 Turn on the camera.
10 Verify that an image appears on the monitor.
Mount the Camera on a Wall
NOTE: Test monitor reception before mounting the camera on a wall. View the image on the monitor while
someone else adjusts the camera position. Optimal camera-to-subject distance for night viewing is
3 – 6 ft (0.9 – 1.8 m).
CAUTION:
Strangulation Hazard–do not place the camera in the crib or
within 3 ft (1 m) of the baby.
1 Select a wall location for the camera, then drill 2 holes in that location using a
13/64 in. (5.2 mm) drill bit. Use the template provided (see page 18).
2 Insert a wall anchor into each hole, then gently tap the anchors with a hammer
until they are seated (flush-mounted) in the wall.
3 Insert the screws into the anchors, then tighten the screws until
approximately 7/32 in. (5.6 mm) of each screw is exposed.
4 Slide the base of the camera over the screws until the camera locks into place.
5 Connect the AC adapter to the camera (or insert 4 AA-size alkaline batteries).
6 Secure the AC adapter cord to the wall with the mounting clips.
urg_01344.book Page 4 Wednesday, October 26, 2011 3:48 PM