Brochure

ManualsBrandsEasy Heat ManualsHeating SuppliesApplication Tape, 1/2" x 30 ft

Table Of Contents

Stop Pipe

and Valve

Freeze-up

•ForMetal

andPlastic

WaterPipes

•With

Energy-saving

Thermostat

HOW TO INSTALL SYSTEM

Tochoosetherightlengthofpipefreezeprotectioncable,

cableshouldbelongenoughtorunalongbottomof

horizontalpipesandweathersideofverticalpipes(in-

cludingvalves)withoutcrossingorspiraling.Neveruse

acablelongerthanthepipeitisintendedtoprotect.

1. Refertothechartinsideoronthepackagefor

propercableselection.

2. Cablewillbeappliedstraightalongpipe,andwill

protectpipesupto1½inchesindiameter.*

3. Forpipelengthsotherthanstandardheatingcablesizes,

andover1/4inchindiameter,usetwoheatingcablesin

parallelonoppositesidesofthepipe(seeillustration).Maxi-

mum“overrun”shouldnotexceed3feet.Do not install on

pipe shorter than 3 feet long.**

4. Wraptheentirepipeandcablewithinsulation.Com-

pletetheinstallationwiththeweatherproofwrapandthe

cautionsigns.Forplasticpipe,werecommendwrapping

pipeinaluminumfoilbeforeinstallingcableforbetterheat

distribution.

PRODUCT SELECTION GUIDE

EasyHeat

DESCRIPTION

ITEM #

 AHB-013 3´LENGTH,21WATTS

 AHB-016 6´LENGTH,42WATTS

 AHB-019 9´LENGTH,63WATTS

 AHB-112 12´LENGTH,84WATTS

 AHB-115 15´LENGTH,105WATTS

 AHB-118 18´LENGTH,126WATTS

 AHB-124 24´LENGTH,168WATTS

 AHB-130 30´LENGTH,210WATTS

 AHB-140 40´LENGTH,280WATTS

 AHB-160 60´LENGTH,420WATTS

 AHB-180 80´LENGTH,560WATTS

 HCA APPLICATIONTAPE

 HCP1 CABLESENTRY

WARNING:EasyHeatrecommendsusingaground

fault protectedreceptacle.

Listed

*Forpipediameters

greaterthan1

inches,

pleasecontactyour

EasyHeatrepresentative.

**Fordetailsplease

contactyourEasyHeat

representative.

EasyHeatproductsareprovidedwithaLIMITEDWARRANTY:

SeeInstallation&OperationInstructionsorcontact

EasyHeatforcompletetermsandconditions.

USA Canada

2ConnecticutSouthDrive 99UnionStreet

EastGranbyCT06026 ElmiraONN3B3L7

Tel 800/537-4732 Tel 519/669-2444

Fax 800/541-7451 Fax 519/669-6419

www.easyheat.com

AHBSeries

ElectricWaterPipe

Freeze

Protection

Cable

AHBHEATINGCABLE/ACCESSORIES

Summary of content (2 pages)

PAGE 1
HOW TO INSTALL SYSTEM To choose the right length of pipe freeze protection cable, cable should be long enough to run along bottom of horizontal pipes and weather side of vertical pipes (including valves) without crossing or spiraling. Never use a cable longer than the pipe it is intended to protect. 1. Refer to the chart inside or on the package for proper cable selection. 2. Cable will be applied straight along pipe, and will protect pipes up to 1½ inches in diameter.* 3.
PAGE 2
Stop Pipe Freeze-up Electric Water Pipe Freeze Protection Cable • Keeps water flowing down to —40°F (—40°C) • Pre-assembled, ready to install EasyHeat, the leader in residential pipe freeze protection, presents the AHB Series pipe heating system. Preassembled and ready-to-install, the cable prevents pipes from freezing, keeping water flowing to —40°. Using an energysaving thermostat, AHB cables operate on 120 Volts AC and are suitable for use on water-filled plastic and metal pipes.