Install Instructions

Table Of Contents

INSTALLATION INSTRUCTIONS

1. Mount the TS-1 securely to a wall or fascia by 2 No.8 screws. Mount in a location that has the same weather conditions

as the snow and ice melting zones. Avoid direct sunlight or warm exhaust vent areas as this may cause erroneous

temperature readings. The unit is water-resistant, but it is not designed to be submerged or immersed in water. Ensure

that the mounting location is close (less than 10 feet) to the MSC-1 Control Panel or a suitable connection box. See Fig.2.

2. The TS-1 connection wire may be extended up to 500’ with an appropriately rated 18-20AWG 3 wire unshielded cable.

Ensure that all electrical connections within connection boxes are sealed to prevent any penetration of water.

3. The TS-1 is wired directly to the temperature sensor terminal block of the MSC-1 control panel.

Figure 2 - TS-1 connection to MSC-1

indoor location

screws

TS-1

Extend to 500´ max;

18 – 20 AWG,

3 conductor unshielded

stranded cable

Access

Cover

MSC-1

Control Panel

TS-1 Installations & Operation Instructions