ACTION CAMCORDER Functions This user's manual has referred to the latest information we had when this user’s manual was made. The screen display and illustrations are used in this user's manual for the purpose of introducing details of this digital camera in a more specific and direct way.
Announcements Please read the Announcements carefully before using this video camera for proper and safe operation, so as to bring its optimum performance into play and extend its service life. u Do not expose the video camera to sunshine directly, nor point its lens to sunlight. sensor of the video camera may be damaged.
agent of video camera for wiping if necessary. Do not use organic solvent to clean the video camera. u Do not touch the lens surface with fingers. u Please back up the data if the memory card inside this video camera is used for the first time. u The externally installed memory cards are manufactured from precise electronic components. Data may be lost or damaged under the following circumstances: 1. Improper use of the memory card. 2. The memory card is bent, dropped or collided. 3.
Waterproof Case Using Notice u Before sealing the waterproof case, keep the camera housing’s rubber seal clean, a single hair or grain of sand can cause a leak. You can test by closing the case without inserting the camera. Submerse the case completely in water for about a minute. Remove the case from the water, dry off its exterior with a towel, then open the case. If the entire interior is dry, the case is safe for use under water.
System Requirements System Requirements Microsoft Windows2000, XP, Vista, 7 Intel Pentium III of more than 800MHz or other CPU with equivalent performance Internal Memory Larger than 512MB Sound Card and The sound card and display card shall support DirectX8 or higher Display Card version. CD Driver Speed of 4 times or faster Hard Disk Free space of more than 500MB Others One standard USB1.1 or USB2.
Introduction to Appearance and Keypad ⑴Memory card slot ⑵Reset ⑶USB slot ⑷Power button ⑸MIC ⑹Shutter button ⑺Mode Switch: ⑻Lens ⑼LCD TFT ⑽Working Indicator Light ⑾Indicator Light for charging ⑿Wrist strap eyelet 5
Usage 1. Charge the built-in lithium battery Indicator Light for charging is on. USB Cable Connect the video camera with computer for charging in the shutdown state. The indicator light for charging is on at this time and will be off after charging. In general, it can be fully charged after 2-4 hours.
2. Use of Memory Card 1. Push the memory card into the card slot according to the concave lettering beside the slot of memory card till it is completely inserted. 2. To take out the memory card, gently press the end of the memory card inward and it will pop up. Note: No built-in memory is available in this video camera. Make sure to insert memory card before using.
3. Startup/Shutdown 3.1 Startup: Press the POWER button for 3 seconds, the screen is displayed and the camera is on. 3.2. Shutdown: Press the POWER Key, and the camera will be shut down. . Automatic shutdown: when the idle time of the video camera reaches the time for automatic shutdown, it will be shut down automatically to save power. The default time of this camera for automatic shutdown is 5 minutes. 3.3.
4. Conversion between Function Modes Three modes are available for this video camera, i.e. picture taking mode, video recording mode and vehicle-mounted mode. Conversion is available via the mode switch after startup. Picture taking mode: pictures can be taken; Video recording mode: video can be recorded; Vehicle-mounted mode: videotape can be recorded.
5. Indicator light Busy light: when the camera is busy (such as, recording a film, taking photos, automatic off-screen), the busy light will be on. Charging light: when the light is on for a long time, it prompts the user that the camera is charging. 6.
5 : digital zoom icon, click and minify it. 7 : visual shutter, touch this visible frame for taking photos or recording. 8 : battery icon, represents the power status of the battery. 9 : represents the status of digital zoom. 10 11 7 : digital zoom icon, click it and enlarge it. 6 : click this icon to switch to the playback mode. : click this icon to set the date and time, finished setting and press Shutter key to confirm.
5 : digital zoom icon, click it to enlarge. 6 : digital zoom icon, click it to minify. 7 : visual shutter, touch this visible frame for taking photos or recording. 8 : battery icon, indicates the power status of the battery. 9 : represents the status of digital zoom. 10 11 8 : click this icon to switch to the playback mode. : click this icon to set the date and time, finished setting and press Shutter key to confirm.
2 : mode icon, representing that the camera is in vehicle-mounted mode. 3 : video size, click this icon to select 720P, VGA. 4 : represents that the memory card has been inserted . 5 : digital zoom icon, click it to enlarge. 6 : digital zoom icon, click it to minify. 7 : visual shutter, touch this visible frame for taking photos or recording. 8 : battery icon, representing the current power status of the battery. 9 : represents the status of digital zoom.
9 Playback mode: 9.1 After starting up and entering the previewing state, click the playback icon ( of the LCD to switch to the playback mode: ) at the lower right corner Click 1 : represents that the current file is an AVI video file. 2 : represents that there is one file in the current folder/one file in total. 3 : current folder name (such as: I:\DCIM\100MEDIA 4 : Means that clicking can select files frontwards. 5 : Means that clicking can select files backwards.
Click to pause playing, click to play forward, and click to play backward. 9.3 File deletion: Click YES to delete the current file immediately, or click NO to cancel the request of deletion.
Apply on the personal computer Connect to personal computer The camera is provided with the plug and play function. Connect the device to the computer with USB line under turning-on state, then it will be switched into the movable hard disk mode. Icon of movable disk will appear on the window of “my computer”. Photos/videos you have taken are saved in folder I:\DCIM\100MEDIA (I is the movable disk of this device) in the movable disk. Files recorded in vehicle-mounted mode are saved in I:\DCIM\RECORDER.
Technical parameters Image sensor Function mode Camera lens Digital zooming Shutter LCD display screen 1.3 million pixel (CMOS) videoing, taking photos, vehicle-mounted mode, removable disk F3.1 f=9.3mm 4 times Electronic shutter 2.0-inch touch screen Image resolution 5M (2592×1944), 3M (2048×1536), 1M(1280×1024) Video resolution White balance Exposure VGA: 640x480 (60 frames/second), 720P:1280x720 (30 frames/second) Automatic Automatic Image JPEG Video AVI Micro SD card (Supporting up to 32GB), min.
This symbol indicates that the relevant electrical product or battery should not be disposed of as general household waste in Europe. To ensure the correct waste treatment of the product and battery, please dispose them in accordance to any applicable local laws of requirement for disposal of electrical equipment or batteries.
NOTE: Please use microSD cards up to 32GB, minimum Class6 (not included). Recording times are depending on resolution. Battery life time - depending on settings and outdoor temperature - up to 90 min. under optimal conditions. Before using your camera in the water please verify that all lids and locks are tightly closed and sealed on the camera and the underwater case. After use, clean the housing of salt and chlorine water and then let it dry.
DECLARATION OF CONFORMITY easypix herebly declares that the product GoXtreme Race is in conformity to all the essential requirements of Directive 1999/5/EC. The declaration of conformity can be downloaded here: http://www.easypix.info/download/pdf/doc_goxtreme_race.pdf For technical help please visit our support area on www.easypix.eu.
