Installation Guide

WALL PLANKS INSTALLATION INSTRUCTION
1. Select orientation: horizontal, vertical or
diagonal.
2. Using a level, draw a line on the wall for
the Starter Plank.
3. Prepare the finishing nails: either install
the enclosed nail strip into the nail gun for
1” long and # 16 Gauge brad nails, or chip
nails from the strip with utility knife for
hummer installation.
4. Apply a starter plank at the line on the wall
and affix it with the nails in each corner of
the plank. Step at least 1 in. from each side
or end of the plank to nail it. For longer
planks apply two more nails in the middle
of the board.
5. If you need to cut planks, use any wood
saw (table saw or hand saw) or cut the
furrow in the wood with a utility knife on
both sides of the plank and break it against
the edge of the table.
6. If you need to attach wall art or shelves on
top of the wall planks, drill the holes and
put hangers through the planks on your
wall. Don’t hang anything heavier than 0.5
lbs. on the planks themselves!
7. Other installation options:
- Double sided sticky foam – we don’t recommend
using them alone (sooner or later planks may fall
down) if you don’t secure planks with nails.
- Adhesive or liquid nails – is not recommended, but
can be applied if you use a contractor for professional
installation. The adhesive should be applied along the
length of the planks with three thin strips (not as
butter on brad distributed evenly (!)):