Installation guide

EASYTOUCH

PL4/PSL4 Control System Installation Guide

CablingtheIndoorControlPanelatthePowerCenter

To connect the indoor control panel cable to the board:

1. Turn off the main system power before making any connections.

2. Run a UL approved four conductor cable (22 AWG) from the indoor control panel to the

Power Center. The preferred wire color scheme is: Red, yellow, green, and black.

3. Route the cable up through the low voltage raceway to the motherboard.

4. Strip back the communication cable conductors ¼ in. Insert the wires into the screw

terminals(providedinthekit).Securethewireswiththescrews.Makesuretomatchthe

color-coding of the wires: Red = +15, Yellow = +DT, Green = -DT, and GND = Black.

5. Insert the cable plug onto the COM-PORT(J20) connector.

6. Proceed with MountandCabletheIndoorControlPanel, page 23.

IntelliFlo Pump

COM Port

COM PORT - J20 connector: For IntelliFlo

Pump, iS4 Spa Side Remote QuickTouch

PL4/PSl4 Control System Indoor Control

Panel and Pl4/PSL4 Control System

Wireless Controller Transceiver.

EasyTouch PL4/PSL4 Control System Circuit Board

ConnectingtheIndoorControlPanelCabletotheEasyTouch

PL4/PSL4

Control System Outdoor Power Center

BEFORE INSTALLING THE Power Center AND POWER CENTER, ALWAYS

SWITCHOFFTHEMAINPOWERintothehomeatthemaincircuitbreakerbox.