Installation guide

26
EASYTOUCH
®
PL4/PSL4 Control System Installation Guide
6. Position the back plate over the mounting points and secure it with the four mounting
screws (provided in the kit).
7. Carefully slide the transceiver circuit board into the back plate.
8. Striptheleadsofthecommunicationcablewiresback¼in.Insertthewiresintothe
connectorscrewterminals(providedinthekit).Usingasmallat-bladescrewdriver,secure
thewireswiththeterminalscrews.Makesuretomatchthecolor-codingofthewires:GND
= Black, Green = -DT, Yellow = +DT, and Red = +15. Connect the screw terminal connector
onto the transceiver circuit board.
9. Slidethecaseoverthebackplate.Securethecasetothebackplateusingthetwo
retaining screws.
10.Proceedwith“Connecting the Transceiver to the EasyTouch PL4/PSL4 Control System
Power Center,” on page 27.
TransceiverModule
Screw terminals
Back plate
Retaining screws
Transceiver circuit board
Case
Knockout hole
Antenna
Mountingpoint(4x)
1 GND BLK
2 - DT GRN
3 + DT YEL
4 15V RED