Instruction manual

10
Operation
Operation is supported by the red/green LED display and an acoustic acknowledgement by means of signal
transmitters.
The key can be used to abort an input procedure.
The procedure is aborted automatically if there is a stop of more than three seconds between operating the
individual keys.
You have four attempts to enter the correct code. After the fourth incorrect entry the entry process is disabled
for one minute as protection against manipulation. The lock is blocked after 100 incorrect entries. Blocking
can only be released with MasterCode2.
All locks in the SAFE-O-TRONIC® LS 100 series are delivered with the same factory setting. The TestCode
for locking and opening is activated in the factory setting.
TestCode
The TestCode can be used to carry out a simple SAFE-O- TRONIC® LS 100 functionality check.
Locking and opening using the TestCode
 Press the 0 key
 Afterwards press the OK key
 Turn the knob
Notice: The TestCode is retained until initial operation.
General Information
Function control
√
X
0