Instruction manual

9
Capacitive keypad
The SAFE-O-TRONIC® LS 100 uses a capacitive keypad.
Notice: The capacitive keypad cannot be operated if you are wearing gloves.
UserCode
The UserCode serves locking or opening of the cabinet or locker by the user. Any four-digit code can be
programmed as the UserCode.
MasterCode1
MasterCode1 serves the plant operator to open the locker. It is intended for employees with restricted
locking authorizations. After being opened, the lock is blocked for the entry of a new UserCode and has to
be released with the help of the MasterCode2. A 5 digit code can be programmed as MasterCode1. If the
employees are only aware of the MasterCode1, they are protected against suspicion in cases of hidden
thefts. It means if there is a theft and the compartment has been locked again, the employees cannot come
into question as offenders.
Notice: MasterCode1 cannot be programmed with 0 as the first number!
MasterCode2
MasterCode2 can be used by the operator of the facility at any time to open and close the compartment or
release the lock. A 5 digit code can be programmed as MasterCode2.
Notice: MasterCode2 cannot be programmed with 0 as the first number!
Code overview
The following table contains an overview of the various codes.
(*) Notice: After using MasterCode1 to open the locker, the lock must be released
by entering MasterCode2 (see page 15).
General Information
4-digit 5 digit Open Close
UserCode
x - x x
MasterCode1
- x x(*) -
MasterCode2
- x x x