Owner`s manual

18
To clean the TPH, begin by removing the cassette drawer from the
scale. Next, using a cotton swab dipped in Denatured Alcohol, gently
slide the cotton swab over the TPH Printing Surface. You can do this
until the alcohol evaporates, but never use excessive force on the
TPH. You can also swab down the Peel Sensor as this device may
also accumulate dust or debris.
You can also use a TPH Cleaner Pen instead of the cotton swab and
Denatured Alcohol. The pen is available through your Easy Weigh
Dealer. When you are done cleaning the TPH, you can replace the
cassette drawer mechanism and test the print quality using the FEED
key. Make sure that the TPH and the Peel Sensor are COMPLETELY
dry of the alcohol before plugging the scale into an AC outlet. You
may also need to clean the Gap Sensor from time to time. To do so,
please follow the instructions located on the cassette drawer.
If you require more thorough or robust cleaning, please contact your
Easy Weigh Dealer.
Power Requirements
The LS-100 is designed to be used virtually anywhere in the world.
Like many appliances of today, the LS-100 is designed with an
automatically switch power supply (ASPS.) this allows operation when
connected to an AC source supplying 85V to 240V AC at 50/60 Hz with
a 5% tolerance.
Remember, an ASPS does not guarantee that a bad, noisy, or
improperly wired power outlet will allow the scale to operate trouble