Owner`s manual

54
Pre-Pack mode and
A
UTO
+
SAVE
are very similar but differ in that
Pre-Pack mode
…
 Automatically prints By Count and By Weight PLUs
 Allows the use of the
X
key
 Does not need to return to gross zero in order to
automatically print again
Pre-pack mode will automatically print again once the weight deviates
by the amount specified in Auto Print Settings, for By Weight PLUs.
To turn Pre-Pack on:
1. Start from the Initial State.
2. Press
PRE PACK
. The Pre-Pack Lamp turns on.
3. Call up a PLU.
4. (Optional) Place an item on the scale.
5. If the Total Price > 0.00, the scale will automatically print.
6. (Optional) Remove the item from the platter.
7. The PLU and/or the unit price and tare (if any) are not cleared.
Steps 2 thru 4 can be done in any order.
To turn Pre-Pack off:
1. Start from the Initial State with the Pre-Pack Lamp on.
2. Press
PRE PACK
. The Pre-Pack Lamp turns off.
3. The PLU and/or the unit price and tare (if any) are cleared.
The Set Key
You can use the
SET
key to enter the Main Menu from the Initial
State or to go to the Initial State from the Main Menu.
The Esc Key
You can use the
ESC
key to go from the Password request screen
to the Initial State or to back up from any submenus within the Main
Menu, until you get to the Main Menu. Once you are at the Main Menu
you can use the
SET
key to go to the Initial State.