Operation Manual

4. Quick Start
CAUTION
• Please install the microscope driver before connecting your microscope to a PC.
• The best way to transfer pictures to PC is by using the Mass Storage mode. Copy all
pictures to your computer in this mode.
• Install Batteries:
1. Rotate the screw .Take off the View case.
2. Slide and open the battery compartment cover.
3. Put in the batteries in the correct direction.+ and –
terminals has shown
.
4. Slide and close the battery compartment cover.
• Insert an SD card:
1.At first, turn off the microscope.
2.Then, insert the card in the correct direction as shown.Push the card
into the slot and be locked.
3. To remove the card, push it in, then release it.When the card is
partially ejected, pull it out.
Note: If the “MEMORY FULL” warning message appears on the
LCD monitor, it means the SD card is full. Please transfer all the files to your computer and
delete the files on the card.Then you can use the card again.
Note: The microscope supports SD card only.
- 5 -